神光Ⅱ上柱形黑腔辐射驱动冲击波

利用神光Ⅱ的八路三倍频激光装置，驱动柱形黑腔产生的x 射线作辐射源驱动台阶铝样品产生冲击波，获得了清晰的冲击波图像，通过冲击波过台阶样 品的时间差获得冲击波速度和压力分别为31.2km/s和17.5×10⁵MPa.采用软x射线能谱 仪通过激光注入孔测量的辐射温度与采用冲击波法测量辐射温度的结果一致. 关键词： 冲击波 辐射驱动 辐射温度     

Hierarchical structures in a turbulent pipe flow

A hierarchical structure (HS) analysis (β-test and γ-test) is applied to a fully developed turbulent pipe flow. Velocity signals are measured at two cross sections in the pipe and at a series of radial locations from the pipe wall. Particular attention is paid to the variation of turbulent statistics at wall units 10<y⁺<3000. It is shown that at all locations the velocity fluctuations satisfy the She–Leveque hierarchical symmetry (Phys. Rev. Lett. 72 (1994) 336). The measured HS parameters, β and γ, are interpreted in terms of the variation of fluid structures. Intense anisotropic fluid structures generated near the wall appear to be more singular than the most intermittent structures in isotropic turbulence and appear to be more outstanding compared to the background fluctuations; this yields a more intermittent velocity signal with smaller γ and β. As turbulence migrates into the logarithmic region, small-scale motions are generated by an energy cascade and large-scale organized structures emerge which are also less singular than the most intermittent structures of isotropic turbulence. At the center, turbulence is nearly isotropic, and β and γ are close to the 1994 She–Leveque predictions. A transition is observed from the logarithmic region to the center in which γ drops and the large-scale organized structures break down. We speculate that it is due to the growing eddy viscosity effects of widely spread turbulent fluctuations in a similar way as in the breakdown of the Taylor vortices in a turbulent Couette–Taylor flow at high Reynolds numbers.     

POROSITY CALCULATION OFMIXTURES OF FIBROUS PARTICLES

The initial forming of fiber blend to high green density, i.e. the packing of fibrous particles, is important to the reinforcement of composite materials. It is very useful to develop a general predictive method for the optimum selection of particle mixtures for the property control of ceramic or composite products. This paper presents such a mathematical model developed on the basis of the similarity analysis between the spherical and non-spherical particle packings and assesses its applicability to the packing of fibrous particles with discrete and/or continuous length distributions. The results indicate that the model can predict this packing system well and hence provide an effective way to solve various packing problems in the composite materials processing.     

HT—6M闭环反馈平衡控制系统

本文描述HT-6M托卡马克装置闭环反馈平衡控制系统的结构组成,通过对各个环节的简化,得到了有效实用的数学模型,进而分析了系统稳态和动态性能。实验结果表明,该系统运行可靠;并且,将等离子体环水平位移控制在2mm以内。     

液态铅的电阻率

采用精确的结构因数实验数据和Ｂｅｈａｖｉ模型赝势，用Ｚｉｍａｎ理论计算了液态铅的电阻率．计算结果和实验数据符合很好．讨论了Ｚｉｍａｎ理论对液态铅的适用性以及适合于液态铅的赝势的特征．     

KrF准分子激光激发掺锗光纤折射率扰动的非线性过程

本文采用了一种简单的功率监测法,观察了KrF准分子激光对掺锗光纤折射率影响的非线性过程。观察到子纤芯折射率扰动过程中非稳定现象、饱和现象和折射率扰动的非线性。     

室温下压致铁钴镍合金的bcc→hcp相变

 本文采用高压X光衍射方法在金刚石对顶压砧中在位地（in situ）研究了Fe₆₈Co₂₄Ni₈（wt%）合金在室温下的压致bcc→hcp结构相变和直到40.5 GPa的等温压缩行为。实验结果表明该合金在常压下为bcc结构，晶格常数a₀=(0.287 0±0.000 1) nm，体积V₀=(7.119±0.007) cm³/mol，密度ρ₀=(7.981±0.008) g/cm³；在20.9 GPa附近出现bcc→hcp结构相变，两相共存压力区约10 GPa，在此区域内有晶面间距d(002)_hcp=d(110)_bcc，且原子平面(002)_hcp//(110)_bcc，hcp相比bcc相体积减小(0.33±0.02) cm³/mol；高压相hcp结构的晶格参数比值c/a=1.608±0.004；相变后原子配位数的增加使得hcp相(002)平面内及(002)平面间的最近邻原子间距比bcc相最近邻原子间距分别增大约1.6%和0.5%；用Murnaghan状态方程对实验数据进行最小二乘法拟合，得到bcc相B₀=(130±13) GPa，B₀'=12.6±0.5；hcp相V₀=(6.62±0.04) cm³/mol，B₀=(243±21) GPa，B₀'=6.8±0.3；对于该合金的bcc→fcp相变时的结构转变机制做了详细的讨论。     

N\bar N annihilation into two body channels

A simple model is constructed forN¯N annihilations into two non-strange mesons. Determining the ratio of isospin one to isospin zero annihilation by experimental information we predict the branching ratios for these channels. The agreement with experiment is surprisingly good.     

延长速调管使用寿命的方法

描述了一种延长EPR波谱仪中速调管使用寿命的方法.根据这种方法,只要正确地调谐微波桥的工作状态和适当地调整功率电平器的功率校正电平.即使对于已经严重老化的速调管仍然可以继续使用一段时间,维持仪器的正常运行.     

Expert systems for HPLC in biochemistry—The knowledge base for selection of HPLC column system in the separation of amino acids,peptides and proteins

The strategy of expert system for high performance liquid chromatography was discussed, the attentions are mainly placed on the knowledge base for selection of column system, separation modes and detection modes in the analysis of amino acids, peptides and proteins.